I really would like to put an AirTech fiberglass tailsection on the bike, but the budget continues to be tight, so we continue with the "use what ya got" theme. I dug up some acrylic sheet, and glued a paper version of the sheetmetal pattern I've been working on for the tailsection. I used a 3/4" bar and a small torch to form the bends on the rough blank. I then took the dremel tool to finish cutting the pattern.
A quick shot of primer, wentsand, a layer of Rustoleum. Viola, a tail is born. Just don't look too close.
No comments:
Post a Comment